Condensation (Tin Cure) Products
| Product ID |
Description
|
Download
|
| GI-2020A |
This activator will dramatically increase the library life of molds from approximately one year to at least ten years. Available in Clear or Pink versions.
|
|
| GI-1000AHT | This activator increases the high temperature resistance from approximately 350°F to approximately 450°F. It will exhibit some inhibition sensitivity. | Data sheet |
| GI-800A | This activator will dramatically increase the library life of molds from approximately one year to at least ten years. | Data sheet |
| GI-179A | This activator can increase tensile strength and elongation while decreasing Shore A or "00" hardness in tin cured silicones under Shore A 25. It will also increase library life of molds or animatronic skins from one year to ten years. | Data sheet |
| GI-177A | This unique activator will give an extremely accelerated work and cure time. Designed to be used with any tin cured base to patch, repair, or "glue" cured silicone. | Data sheet |
| UFC | Ultra Fast Catalyst, allows you to cure the silicone much faster without dramatically increasing the embrittling of the cured silicone. | Data sheet |
| GI-245 A-2 | When added to GI-1110, GI-587 or GI-245, the silicone will be softened and the elongation increased without a dramatic increase in bleed out as seen with traditional softeners. | Data sheet |
| Paint System | A one component silicone suspended in a non hydrocarbon solvent used as a carrier when externally painting a cured silicone piece such as in animatronics or medical simulators. | Data sheet |
Addition (Platinum Cure) Products
| Product ID |
Description
|
Download
|
| PT-Accelerator |
When added to any platinum cure products in very small amounts, the curing reaction is dramatically accelerated at room temperature.
|
Contact Silicones, Inc.
for further technical assistance |
| XP-588 | When added to any platinum cure product, it will accelerate the cure rate. It is a diluted version of PT-Accelerator. | Contact Silicones, Inc. for further technical assistance |
| P-684 | When added to P-656, the silicone will be softened without a dramatic increase in leaching of silicone oils. | Data sheet |
| P-690 | When added to P-656, the silicone will be softened and a sticky surface will be obtained, enhancing prosthetic pieces' ability to adhere to skin. This will not give permanent adhesion acting alone. | Data sheet |
Both Condensation & Addition Products
| Product ID |
Description
|
Download
|
| SI-661 |
When added to certain silicones, it will create a non-flowing (thixotropic) effect, allowing the silicone to be applied to vertical surfaces or for glove molding.
|
|
| SI-Thinner | A non-reactive silicone oil used to lower the viscosity of any silicone. The mechanical properties of the cured rubber will be changed. | Data sheet |
| SI-Primer | When used on a non-silicone substrate, it promotes the adhesion of the silicone. Must be applied prior to pouring the silicone onto select surfaces (non-silicone substrates) to obtain cohesion failure (sticking). | Data sheet |
| SI-479 | A silicone-based solvent that can be used to clean cured silicone or as a diluent for the Paint System. | Data sheet |
The information contained in this selection guide is, to our best knowledge, true and accurate, but all recommendations or suggestions are made without guarantee. Since the conditions of use are beyond our control, Silicones, Inc. disclaims any liability incurred in connection with the use of our products and information contained herein.